Quality, safety and sustainability
Tested before it ships
Certified to the international standards for quality, environment and safety, and measured on the energy our motors save.
Standards we’re certified to
All three factories hold the same certificates, audited each year by an accredited certification body.
-
ISO 9001
Quality management
-
ISO 14001
Environmental management
-
ISO 45001
Occupational health and safety
-
ATEX
Motors for explosive atmospheres
-
IECEx
International hazardous area certification
-
DNV
Marine type approval for propulsion motors
-
ECAS
UAE conformity for motors (demo)
-
SASO
Saudi product conformity (demo)
1,412
days without a lost-time injury across our factories
Certificates and approvals
Our quality management system is certified to ISO 9001:2015 (certificate NQ-9001-0412, demo), our environmental management system to ISO 14001:2015 (NE-14001-0412, demo) and our health and safety management system to ISO 45001:2018 (NS-45001-0412, demo). The scope covers the design, manufacture, testing and service of electric motors, gearboxes and drive systems at Jebel Ali, Dammam and Sohar.
Hazardous area motors are certified under ATEX and the IECEx scheme, for gas groups IIA to IIC and dust zones 21 and 22. Marine propulsion motors hold DNV type approval. Our motors carry the UAE conformity mark under ECAS and Saudi SASO certificates for sale in each country (both demo). Copies of every certificate are sent on request with your quotation.
How every motor is tested
-
Incoming inspection
Steel, copper, magnets and bearings checked against their certificates before they reach the line.
-
In-process checks
Winding resistance, surge and insulation tests on every stator before it’s fitted.
-
Routine test
No-load, locked-rotor, vibration and high-voltage tests to IEC 60034-1 on every finished motor.
-
Load test
Full-load heat run for every motor above 200 kW, and for any motor you ask to witness.
Energy and emissions
- saved each year
- 410 GWh
- By IE5 motors we shipped in 2025, against IE3
- lower scope 1 and 2 emissions
- 46%
- Since 2019, across all three factories
- solar and clean electricity
- 100%
- At Jebel Ali since 2023
- of copper and steel recovered
- 92%
- From the motors we rewind and scrap
Our net zero plan
The biggest difference we make is in the field: an electric motor uses its purchase price in electricity every few months, so efficiency matters far more than how it was made. That’s why every quote above 11 kW includes an energy comparison, and why we recommend repair rather than replacement when the numbers say so.
In our own factories we’ve committed to net zero scope 1 and 2 emissions by 2032. The Jebel Ali works runs on its 1.8 MWp solar roof and clean energy certificates, Dammam recycles all of its process water, and Sohar will install its own solar array in 2027.
Quality questions
Can I audit your factory?
Yes. Customer audits are welcome at any of our three factories with two weeks’ notice. Contact your project manager or use the contact form.
Do your motors meet GCC efficiency rules?
Yes. Every NA and NX motor meets or exceeds the minimum energy performance standards for motors in the UAE (ESMA, demo) and Saudi Arabia (SASO, demo), and carries CE marking for export.
What is your safety record?
1,412 days without a lost-time injury across our three factories at the end of September 2026, and an accident frequency rate below 0.1 per 100,000 hours worked.
Need certificates for a tender?
We’ll send certificates, policies and test procedures with your quotation.